The system came in a well packaged box and I found everything easily including some spare parts for future use, which I appreciate. Fittings and pipes were included. All I need was the tools (wrench, scissors, etc) and a Teflon sealer that I got from Home Depot. I noticed a little trace of water and I found out that iSpring did a real test for quality control so that's a good ... full review
Photo by F. TronchinDepending on the geographic location of the wilderness area you are visiting and the time of year, temperatures can vary dramatically over the course of 24 hours. Layer your clothing to stay warm and keep your pack light. Pack silk long johns, t-shirts, trekking pants that convert to shorts, underwear, socks, and nightclothes. A fleece jacket, windbreaker, and waterproof outer jacket should be enough to handle most conditions. Wear a good pair of hiking boots, but pack a pair of sandals and water shoes. Round out your wardrobe with gloves, hat, and a scarf.

Within the United States Marine Corps, the reverse osmosis water purification unit has been replaced by both the Lightweight Water Purification System and Tactical Water Purification Systems.[14] The Lightweight Water Purification Systems can be transported by Humvee and filter 470 litres (120 US gal) per hour. The Tactical Water Purification Systems can be carried on a Medium Tactical Vehicle Replacement truck, and can filter 4,500 to 5,700 litres (1,200 to 1,500 US gal) per hour.[citation needed]

After installation, you have to fill and empty the tank to make it active. Normally you have filled and empty for 3-4 times but it depends on the system. You can check out how much water wastage is required from your instructional manual. This step in crucial. You will not have the safer, cleaner healthier purified water until you complete the last step.


The water from this unit is pretty much tasteless to me, which is ideal since tap water tastes awful. I grew up with Culligan, which has a certain taste to me, versus this which is just pure. Haven't tested it but plan to. We also added a line to the fridge ice maker so our ice is purified. It was easy to install in our home, and we've used it three months with no issues. The cables are long. today when our sink clogged and we had to drain it, got a mess over all the filters, and they water tubes were all long enough to put the whole unit (still assembled and attached), into the sink to rinse it off. I'm glad it's made in the USA so I know all the parts have stringent manufacturing guidelines. The only thing I would change, is ordering directly from apec instead ... full review 

In 1904, Allen Hazen showed that the efficiency of a sedimentation process was a function of the particle settling velocity, the flow through the tank and the surface area of tank. Sedimentation tanks are typically designed within a range of overflow rates of 0.5 to 1.0 gallons per minute per square foot (or 1.25 to 2.5 litres per square meter per hour). In general, sedimentation basin efficiency is not a function of detention time or depth of the basin. Although, basin depth must be sufficient so that water currents do not disturb the sludge and settled particle interactions are promoted. As particle concentrations in the settled water increase near the sludge surface on the bottom of the tank, settling velocities can increase due to collisions and agglomeration of particles. Typical detention times for sedimentation vary from 1.5 to 4 hours and basin depths vary from 10 to 15 feet (3 to 4.5 meters).[6]:9.39–9.40[7]:790–1[8]:140–2, 171
×