While reverse osmosis systems are widely used for industrial and commercial purposes, smaller home units can be purchased and installed under the kitchen sink and dispensed through the faucet. Home RO units typically run on a 3-stage system which includes a carbon filter, RO membrane, and re-mineralizing filter for taste. Some systems can include 5, 7, or even 10 stages. While the additional stages offer extra benefits such as pH level balance and UV filtration, a simple 3-stage system has everything required to produce pure, drinkable water. RO systems require frequent maintenance and replacement of filters in order to keep it functioning properly. Read our article on reverse osmosis systems for home use for a detailed guide on how they work and which brands to use.
The other options involve chemical agents. Hikers have long been familiar with using iodine tablets to kill microorganisms in local water sources. A typical example would be a tiny pellet being good for a quart of water. Bleach has been popular in poorer countries for decades as a means of killing microorganisms in local tap water, and works just as well with other sources. Eight drops per gallon will make the water safe to drink. Both methods should be allowed half an hour to do their job.

The EPA states that there are four main types of contaminants to be found in water. The Safe Drinking Water Act (SDWA), a federal law that protects public drinking water supplies, defines "contaminant" as anything other than water molecules. We can reasonably expect most drinking water to contain some level of contaminant, especially since minerals such as calcium and magnesium fall into that category. The question is, which of these contaminants are harmful and how much of it is entering my system?


Filter out pathogens with pine trees. Certain plants are effective at removing pathogens from water, and pine trees are among the best. To remove viruses and bacteria from your water, remove a small branch from a pine tree. Strip the bark from the stick and place the bare stick into a bucket. Slowly pour the water, letting it trickle onto the stick and into the bucket.[10]

Many municipalities have moved from free chlorine to chloramine as a disinfection agent. However, chloramine appears to be a corrosive agent in some water systems. Chloramine can dissolve the "protective" film inside older service lines, leading to the leaching of lead into residential spigots. This can result in harmful exposure, including elevated blood lead levels. Lead is a known neurotoxin.[31]

Strain the water. For water that’s contaminated with large particles like pebbles, insects, plant matter, or dirt, you can strain out the contaminants.[1] Line a fine-mesh strainer with muslin, cheesecloth, a clean dish towel, or even a clean cotton shirt. Place the strainer over a bowl, and pour the water through the strainer to remove the particles.
In Situ Chemical Oxidation, a form of advanced oxidation processes and advanced oxidation technology, is an environmental remediation technique used for soil and/or groundwater remediation to reduce the concentrations of targeted environmental contaminants to acceptable levels. ISCO is accomplished by injecting or otherwise introducing strong chemical oxidizers directly into the contaminated medium (soil or groundwater) to destroy chemical contaminants in place. It can be used to remediate a variety of organic compounds, including some that are resistant to natural degradation
While the intermittent nature of sunlight and its variable intensity throughout the day makes PV efficiency prediction difficult and desalination during night time challenging, several solutions exist. For example, batteries, which provide the energy required for desalination in non-sunlight hours can be used to store solar energy in daytime. Apart from the use of conventional batteries, alternative methods for solar energy storage exist. For example, thermal energy storage systems solve this storage problem and ensure constant performance even during non-sunlight hours and cloudy days, improving overall efficiency.[13]
After Hurricane Sandy, many homeowners used portable generators to replace lost power, leaving the machines running overnight and allowing odorless carbon monoxide to waft inside. The gas induces dizziness, headaches, and nausea in people who are awake, but "when people go to sleep with a generator running, there's no chance for them to realize that something's wrong," says Brett Brenner, president of the Electrical Safety Foundation International.
You do not want to wait until you are thirsty to begin gathering water, as the urge to drink directly from the contaminated source can become unbearable. Due to the negative effects of drinking water contaminated with Giardia and other bacteria/viruses, this is a bad idea. Becoming sick from drinking bad water, will further dehydrate you, worsening your situation.

Treatment with reverse osmosis is limited, resulting in low recoveries on high concentration (measured with electrical conductivity) and fouling of the RO membranes. Reverse osmosis applicability is limited by conductivity, organics, and scaling inorganic elements such as CaSO4, Si, Fe and Ba. Low organic scaling can use two different technologies, one is using spiral wound membrane type of module, and for high organic scaling, high conductivity and higher pressure (up to 90 bars) disc tube modules with reverse-osmosis membranes can be used. Disc tube modules were redesigned for landfill leachate purification, that is usually contaminated with high levels of organic material. Due to the cross-flow with high velocity it is given a flow booster pump, that is recirculating the flow over the same membrane surface between 1.5 and 3 times before it is released as a concentrate. High velocity is also good against membrane scaling and allows successful membrane cleaning.
The first part of the purification tag team must eliminate microorganisms, like harmful bacteria and parasites. There are a handful of tried and true methods for doing this. The most familiar is boiling. Simply bringing water up to its boiling point of 212 degrees Fahrenheit will kill almost all microorganisms, so just a few minutes of boiling will do the job.
Many books and articles suggest this method as a safe alternative when lacking water filtration or purification methods. Without testing equipment some methods are difficult to prove. Norseman of Survivology 101 posted two great blogs which include testing done while he trained with the Norwegian school of Winter Warfare. The testing shows that the Mash or Seep showed zero improvement in lowering the bacterial count. Norseman is a retired Marine who held a Scout Sniper Survival instructor position at the First Marine Division, and SERE instructor.
If you want to take a long swim underwater, the trick is to breathe in and out a few times and take a big gulp of air before you submerge. Right? Dead wrong. Hyperventilating not only doesn't increase the oxygen in your blood, it also decreases the amount of CO2, the compound that informs the brain of the need to breathe. Without that natural signal, you may hold your breath until you pass out and drown. This is known as shallow-water blackout.
You have successfully negotiated free fall, deployed your canopy, and are about to touch down. Safe? Nope. Inexperienced solo jumpers trying to avoid an obstacle at the last minute, or experienced skydivers looking for a thrill, might sometimes pull a toggle and enter a low-hook turn. "If you make that turn too low, your parachute doesn't have time to level out," says Nancy Koreen of the United States Parachute Association. Instead, with your weight far out from the canopy, you'll swing down like a wrecking ball.
If the right equipment is available distillation is another way to ensure removal of bacteria and viruses. This is one method that will allow us to use salt water for drinking. Note: If you own a boat and use it for off shore trips a desalinator such as the Katadyn Survivor series would be a prudent purchase. The Katadyn Survivor 40E can be operated manually or using 12/24 V DC power. We will cover makeshift ways of distillation in future articles.
Gas hydrate crystals centrifuge method. If carbon dioxide or other low molecular weight gas is mixed with contaminated water at high pressure and low temperature, gas hydrate crystals will form exothermically. Separation of the crystalline hydrate may be performed by centrifuge or sedimentation and decanting. Water can be released from the hydrate crystals by heating[25]
Advantage is that you are not adding any chemicals to your water, which takes out the guess work as far as dosage. The disadvantage, if it can even be called that, is that you have to have a source of heat(fire, stove, etc.) in order to bring the water to the boiling point. Also we have to remember that this does not remove chemical such as petroleum or pesticides which can be harmful as well.

Found on small or moderate-size streams and rivers, low-head dams are used to regulate water flow or prevent invasive species from swimming upstream. But watch out. "They're called drowning machines because they could not be designed better to drown people," says Kevin Colburn of American Whitewater, a nonprofit whitewater preservation group. To a boater heading downstream, the dams look like a single line of flat reflective water. But water rushing over the dam creates a spinning cylinder of water that can trap a capsized boater.
The booster pump included with this tankless reverse osmosis system requires electricity but helps to maximize the efficiency of the system. It can achieve up to a 1:1 ratio of purified to wastewater. However, in real-world use, some people found that wastewater was more like 2 gallons for every 1 gallon of purified water produced. iSprings points out that many factors affect this efficiency rating, so some variance in results is to be expected.
As with any other filter type water purification method, careful attention has to be taken to pathogen/virus and chemicals size. During hurricane Katrina a lot of the water was contaminated with petroleum based chemicals from flooded cars. What is removed from the water is dependent on the filter pore size. However, it is difficult to beat the lightweight option that water purification straws and bottles provide for most situations.
×