You can get an unlimited supply of pure water right from your kitchen. It can remove 99% of harmful contaminants from the feed water. The quality of filtered water depends upon the feed water. If you have doubt on your water source or have a large number of microorganisms then you should not rely on this RO Unit as it does not have the advanced stages like UV Filter which can deal with the microorganisms.
Many books and articles suggest this method as a safe alternative when lacking water filtration or purification methods. Without testing equipment some methods are difficult to prove. Norseman of Survivology 101 posted two great blogs which include testing done while he trained with the Norwegian school of Winter Warfare. The testing shows that the Mash or Seep showed zero improvement in lowering the bacterial count. Norseman is a retired Marine who held a Scout Sniper Survival instructor position at the First Marine Division, and SERE instructor.
Remineralization stage adds back some beneficial minerals such as magnesium, calcium, and potassium to the purified water. This process is introduced to overcome the problem of acidic water. This addition of minerals gives the taste back to the water, which is removed in final filters. Remineralization enhanced the experience of purified water but it also makes the water more alkaline and less acidic.
Iodine solutions kill bacteria by upsetting the ion balance within the cell, replacing chemicals that the bacteria needs to survive with iodide ions. Iodine can also be poisonous to humans, and can be especially harmful to young children, and pregnant women. You should be careful not to use too much iodine when purifying your water, and if at all possible avoid using it as a primary purification method for extended periods of time. If you find yourself in a survival situation, for an extended period of time, you should consider setting up a still, or boiling the water if possible.
Chlorine dioxide is a faster-acting disinfectant than elemental chlorine. It is relatively rarely used because in some circumstances it may create excessive amounts of chlorite, which is a by-product regulated to low allowable levels in the United States. Chlorine dioxide can be supplied as an aqueous solution and added to water to avoid gas handling problems; chlorine dioxide gas accumulations may spontaneously detonate.
Photo by mr.smashyContingencies in the wilderness abound, so it is important to plan for as many as possible. A compass will help you find your way; even better is a handheld GPS device. Flashlights and glow sticks help you find your way in the dark, and a flare gun will assist others in finding you during an emergency. For setting up camp, Paracord or rope, a tarp, duct tape, and cable ties are indispensable. Also vital is a good multi-tool, folding shovel, and gloves. Include waterproof matches, lighter, and fire starting kit; redundancy is a good thing in this instance. In a small tin, pack fishhooks and line, razor blades, sewing needles and thread, safety pins, nails, a small magnet, and some cash.
In 1904, Allen Hazen showed that the efficiency of a sedimentation process was a function of the particle settling velocity, the flow through the tank and the surface area of tank. Sedimentation tanks are typically designed within a range of overflow rates of 0.5 to 1.0 gallons per minute per square foot (or 1.25 to 2.5 litres per square meter per hour). In general, sedimentation basin efficiency is not a function of detention time or depth of the basin. Although, basin depth must be sufficient so that water currents do not disturb the sludge and settled particle interactions are promoted. As particle concentrations in the settled water increase near the sludge surface on the bottom of the tank, settling velocities can increase due to collisions and agglomeration of particles. Typical detention times for sedimentation vary from 1.5 to 4 hours and basin depths vary from 10 to 15 feet (3 to 4.5 meters).[6]:9.39–9.40[7]:790–1[8]:140–2, 171
×