The system came in a well packaged box and I found everything easily including some spare parts for future use, which I appreciate. Fittings and pipes were included. All I need was the tools (wrench, scissors, etc) and a Teflon sealer that I got from Home Depot. I noticed a little trace of water and I found out that iSpring did a real test for quality control so that's a good ... full review
Whether you are on a backpacking trip or find yourself in an unplanned emergency situation our first goal is to locate water. Depending on the location this may prove more difficult than ensuring it's potability. Make sure you are familiar with water sources in the area you plan to travel. Looking at topographical maps is always a good idea. Depending on the dates of the map this could help you find water while backpacking. As with other areas of emergency preparedness, make sure to have a backup plan. Water sources can change with time and seasonal changes. Another important aspect of finding water is the lay of the land. Learning the elevational changes of the area and thinking which way the water would travel during a rain can be another way to locate a water source. For the scope of this article, we will assume that a source has been located.
Boiling: Bringing water to its boiling point (about 100 °C or 212 F at sea level), is the oldest and most effective way since it eliminates most microbes causing intestine related diseases,[21] but it cannot remove chemical toxins or impurities.[22] For human health, complete sterilization of water is not required, since the heat resistant microbes are not intestine affecting.[21] The traditional advice of boiling water for ten minutes is mainly for additional safety, since microbes start getting eliminated at temperatures greater than 60 °C (140 °F). Though the boiling point decreases with increasing altitude, it is not enough to affect the disinfecting process.[21][23] In areas where the water is "hard" (that is, containing significant dissolved calcium salts), boiling decomposes the bicarbonate ions, resulting in partial precipitation as calcium carbonate. This is the "fur" that builds up on kettle elements, etc., in hard water areas. With the exception of calcium, boiling does not remove solutes of higher boiling point than water and in fact increases their concentration (due to some water being lost as vapour). Boiling does not leave a residual disinfectant in the water. Therefore, water that is boiled and then stored for any length of time may acquire new pathogens.
STAT: The number of annual deaths from ESD in the U.S. are unknown, since they are counted among all drownings. But anecdotal evidence shows that ESD is widespread. ESD prevention groups have successfully urged some states to enact safety standards, including the installation of ground-fault circuit interrupters and a central shutoff for a dock's electrical system.
×