The remineralization stage is an additional feature of this water purifier. The name itself explains the function of this stage. After passing through the basic 5 stages of filtration the water is treated in the remineralization stage. At this point of purification, some advantageous minerals restored into the water again. The added minerals improve the taste and raise the pH to more alkaline. You will definitely enjoy the fresher tasting mineral water.
Groundwater: The water emerging from some deep ground water may have fallen as rain many tens, hundreds, or thousands of years ago. Soil and rock layers naturally filter the ground water to a high degree of clarity and often, it does not require additional treatment besides adding chlorine or chloramines as secondary disinfectants. Such water may emerge as springs, artesian springs, or may be extracted from boreholes or wells. Deep ground water is generally of very high bacteriological quality (i.e., pathogenic bacteria or the pathogenic protozoa are typically absent), but the water may be rich in dissolved solids, especially carbonates and sulfates of calcium and magnesium. Depending on the strata through which the water has flowed, other ions may also be present including chloride, and bicarbonate. There may be a requirement to reduce the iron or manganese content of this water to make it acceptable for drinking, cooking, and laundry use. Primary disinfection may also be required. Where groundwater recharge is practiced (a process in which river water is injected into an aquifer to store the water in times of plenty so that it is available in times of drought), the groundwater may require additional treatment depending on applicable state and federal regulations.
You do not want to wait until you are thirsty to begin gathering water, as the urge to drink directly from the contaminated source can become unbearable. Due to the negative effects of drinking water contaminated with Giardia and other bacteria/viruses, this is a bad idea. Becoming sick from drinking bad water, will further dehydrate you, worsening your situation.
In a reverse osmosis filter system, your regular water pressure pushes the water through a membrane and additional filters to remove impurities, which are then flushed down the drain. It’s a rigorous filtering process, a GE Reverse Osmosis System filters water three times, for example. Membranes and filters need to be replaced every six months to two years depending on the type of filter and how much water you use.
Some water supplies may also contain disinfections by-products, inorganic chemicals, organic chemicals, and radionuclides. Specialized methods for controlling formation or removing them can also be part of water treatment. To learn more about the different treatments for drinking water, see the National Drinking Water Clearinghouse’s Fact Sheet Series on Drinking Water TreatmentsExternal.
Membrane filters are widely used for filtering both drinking water and sewage. For drinking water, membrane filters can remove virtually all particles larger than 0.2 μm—including giardia and cryptosporidium. Membrane filters are an effective form of tertiary treatment when it is desired to reuse the water for industry, for limited domestic purposes, or before discharging the water into a river that is used by towns further downstream. They are widely used in industry, particularly for beverage preparation (including bottled water). However no filtration can remove substances that are actually dissolved in the water such as phosphates, nitrates and heavy metal ions.
Energy-recovery pump: a reciprocating piston pump having the pressurized concentrate flow applied to one side of each piston to help drive the membrane feed flow from the opposite side. These are the simplest energy recovery devices to apply, combining the high pressure pump and energy recovery in a single self-regulating unit. These are widely used on smaller low-energy systems. They are capable of 3 kWh/m3 or less energy consumption.
Cut the bottom of a plastic bottle off -- these can be found almost everywhere at no cost. Replace the bottle cap with a cheesecloth/fine cloth, tied on with a rubber band and secure. Place it on a cup, with the cloth facing towards the ground. Put fine sand, charcoal, coarse sand and rocks in the bottle in the order listed. Pour water inside. Capture the water that has now been purified.
Ozone has been used in drinking water plants since 1906 where the first industrial ozonation plant was built in Nice, France. The U.S. Food and Drug Administration has accepted ozone as being safe; and it is applied as an anti-microbiological agent for the treatment, storage, and processing of foods. However, although fewer by-products are formed by ozonation, it has been discovered that ozone reacts with bromide ions in water to produce concentrations of the suspected carcinogen bromate. Bromide can be found in fresh water supplies in sufficient concentrations to produce (after ozonation) more than 10 parts per billion (ppb) of bromate — the maximum contaminant level established by the USEPA. Ozone disinfection is also energy intensive.
Ultraviolet light (UV) is very effective at inactivating cysts, in low turbidity water. UV light's disinfection effectiveness decreases as turbidity increases, a result of the absorption, scattering, and shadowing caused by the suspended solids. The main disadvantage to the use of UV radiation is that, like ozone treatment, it leaves no residual disinfectant in the water; therefore, it is sometimes necessary to add a residual disinfectant after the primary disinfection process. This is often done through the addition of chloramines, discussed above as a primary disinfectant. When used in this manner, chloramines provide an effective residual disinfectant with very few of the negative effects of chlorination.