A specific "large-scale" form of slow sand filter is the process of bank filtration, in which natural sediments in a riverbank are used to provide a first stage of contaminant filtration. While typically not clean enough to be used directly for drinking water, the water gained from the associated extraction wells is much less problematic than river water taken directly from the river.
Water filtration is probably the most common method of purification for personal consumption, mainly because of its versatility and ease of use. Water filtration systems come in many forms and sizes, some of which are even portable. The most common water filtration systems are integrated with household sinks and refrigerators by connecting to the waterline.
Treatment with reverse osmosis is limited, resulting in low recoveries on high concentration (measured with electrical conductivity) and fouling of the RO membranes. Reverse osmosis applicability is limited by conductivity, organics, and scaling inorganic elements such as CaSO4, Si, Fe and Ba. Low organic scaling can use two different technologies, one is using spiral wound membrane type of module, and for high organic scaling, high conductivity and higher pressure (up to 90 bars) disc tube modules with reverse-osmosis membranes can be used. Disc tube modules were redesigned for landfill leachate purification, that is usually contaminated with high levels of organic material. Due to the cross-flow with high velocity it is given a flow booster pump, that is recirculating the flow over the same membrane surface between 1.5 and 3 times before it is released as a concentrate. High velocity is also good against membrane scaling and allows successful membrane cleaning.
The Lifestraw go simplifies water purification by allowing users to scoop water from a river or other unsafe water source into the bottle, screw the lid on, and sip clean water through the mouthpiece. We have not had the opportunity to test the Lifestraw go. We would be interested in comparing it to the Sawyer Personal Water Bottle. Our next post will be a test of the Sawyer bottle.

Inclined flat plates or tubes can be added to traditional sedimentation basins to improve particle removal performance. Inclined plates and tubes drastically increase the surface area available for particles to be removed in concert with Hazen's original theory. The amount of ground surface area occupied by a sedimentation basin with inclined plates or tubes can be far smaller than a conventional sedimentation basin.
To clean the filter, water is passed quickly upward through the filter, opposite the normal direction (called backflushing or backwashing) to remove embedded or unwanted particles. Prior to this step, compressed air may be blown up through the bottom of the filter to break up the compacted filter media to aid the backwashing process; this is known as air scouring. This contaminated water can be disposed of, along with the sludge from the sedimentation basin, or it can be recycled by mixing with the raw water entering the plant although this is often considered poor practice since it re-introduces an elevated concentration of bacteria into the raw water.
A properly packed backpack is requisite to your comfort and safety. Incorrect weight distribution leads to muscle aches and unnecessary strain on your spine. Place heavy items – water, food, and cooking gear – in the middle of your pack, close to your body. Use medium weight items – clothing, tarps, and rain gear – to cushion the heavier items, securing them, so the weight does not shift while you are hiking. Pack your sleeping bag in the bottom of your backpack or tie to the bottom. Store items that you are likely to need more frequently in the side and outer pockets – compass and map, sunglasses, toilet tissue and trowel, sunscreen, bug repellent, pocketknife, flashlight, snacks, and a small towel.
In 1904, Allen Hazen showed that the efficiency of a sedimentation process was a function of the particle settling velocity, the flow through the tank and the surface area of tank. Sedimentation tanks are typically designed within a range of overflow rates of 0.5 to 1.0 gallons per minute per square foot (or 1.25 to 2.5 litres per square meter per hour). In general, sedimentation basin efficiency is not a function of detention time or depth of the basin. Although, basin depth must be sufficient so that water currents do not disturb the sludge and settled particle interactions are promoted. As particle concentrations in the settled water increase near the sludge surface on the bottom of the tank, settling velocities can increase due to collisions and agglomeration of particles. Typical detention times for sedimentation vary from 1.5 to 4 hours and basin depths vary from 10 to 15 feet (3 to 4.5 meters).[6]:9.39–9.40[7]:790–1[8]:140–2, 171
Visual inspection cannot determine if water is of appropriate quality. Simple procedures such as boiling or the use of a household activated carbon filter are not sufficient for treating all possible contaminants that may be present in water from an unknown source. Even natural spring water – considered safe for all practical purposes in the 19th century – must now be tested before determining what kind of treatment, if any, is needed. Chemical and microbiological analysis, while expensive, are the only way to obtain the information necessary for deciding on the appropriate method of purification.
The water from this unit is pretty much tasteless to me, which is ideal since tap water tastes awful. I grew up with Culligan, which has a certain taste to me, versus this which is just pure. Haven't tested it but plan to. We also added a line to the fridge ice maker so our ice is purified. It was easy to install in our home, and we've used it three months with no issues. The cables are long. today when our sink clogged and we had to drain it, got a mess over all the filters, and they water tubes were all long enough to put the whole unit (still assembled and attached), into the sink to rinse it off. I'm glad it's made in the USA so I know all the parts have stringent manufacturing guidelines. The only thing I would change, is ordering directly from apec instead ... full review

Each branch of the United States armed forces has their own series of reverse osmosis water purification unit models, but they are all similar. The water is pumped from its raw source into the reverse osmosis water purification unit module, where it is treated with a polymer to initiate coagulation. Next, it is run through a multi-media filter where it undergoes primary treatment by removing turbidity. It is then pumped through a cartridge filter which is usually spiral-wound cotton. This process clarifies the water of any particles larger than 5 µm and eliminates almost all turbidity.
There are multiple levels of filtration. As long as the water has been purified properly, filtration at this point would mostly be to make the water more attractive. Since most of us are not used to, drinking water with, leaves, algae, dirt, etcetera. So, at least a minimal amount of filtration is recommended. Since, while you can ingest/digest the aforementioned, most of us would prefer not to.
The other half of the tag team is to eliminate pollutants. The best way to do this is with a homemade carbon filter. This uses the same technology as Brita filters. Carbon is a chemically active substance, with a tendency to bind to most anything. At a microscopic level, charcoal is a heavily pitted and striated material, which vastly increases its real surface area. The result is that when water slowly runs over charcoal, pollutants find themselves glued to the charcoal surface. An improvised filter can be made out of ground-up charcoal, a strainer and a funnel. Bear Gryllis made a purification drinking straw out of little more than a reed and some charcoal bits for the Discovery Channel's "Man vs. Wild." It's a simple technique, but it is highly effective.
The other options involve chemical agents. Hikers have long been familiar with using iodine tablets to kill microorganisms in local water sources. A typical example would be a tiny pellet being good for a quart of water. Bleach has been popular in poorer countries for decades as a means of killing microorganisms in local tap water, and works just as well with other sources. Eight drops per gallon will make the water safe to drink. Both methods should be allowed half an hour to do their job.

Waters exiting the flocculation basin may enter the sedimentation basin, also called a clarifier or settling basin. It is a large tank with low water velocities, allowing floc to settle to the bottom. The sedimentation basin is best located close to the flocculation basin so the transit between the two processes does not permit settlement or floc break up. Sedimentation basins may be rectangular, where water flows from end to end, or circular where flow is from the centre outward. Sedimentation basin outflow is typically over a weir so only a thin top layer of water—that furthest from the sludge—exits.
Reverse osmosis (RO) is a water purification process that uses a partially permeable membrane to remove ions, unwanted molecules and larger particles from drinking water. In reverse osmosis, an applied pressure is used to overcome osmotic pressure, a colligative property that is driven by chemical potential differences of the solvent, a thermodynamic parameter. Reverse osmosis can remove many types of dissolved and suspended chemical species as well as biological ones (principally bacteria) from water, and is used in both industrial processes and the production of potable water. The result is that the solute is retained on the pressurized side of the membrane and the pure solvent is allowed to pass to the other side. To be "selective", this membrane should not allow large molecules or ions through the pores (holes), but should allow smaller components of the solution (such as solvent molecules, i.e., water, H2O) to pass freely.[1]

A nice feature of the Sawyer system is the benefit of using the same filter as a water treatment bottle, inline on a hydration pack, as an ultra light drink straw and attached to a faucet with the included faucet adaptor. If purchased with the faucet adaptor kit, it can be configured to drink straight from the tap during boil alerts or in areas of natural disasters such as floods, hurricanes, and earthquakes. The kit also provides hydration pack assembly kit for installing the inline filter on a hydration pack.
Many municipalities have moved from free chlorine to chloramine as a disinfection agent. However, chloramine appears to be a corrosive agent in some water systems. Chloramine can dissolve the "protective" film inside older service lines, leading to the leaching of lead into residential spigots. This can result in harmful exposure, including elevated blood lead levels. Lead is a known neurotoxin.[31]
"The overall study results revealed that the CHLOR-FLOC system was not adequate to physically remove, or to provide adequate chemical disinfection of, Cryptosporidium oocysts to the required level of 99.9 percent reduction. Water, Purification, CHLOR-FLOC tablets, Micro-organisms, Cryptosporidium, Klebseilla, Echovirus, Latex beads, Protozoan cysts, Bacteria, Disinfection, Coagulation." Source: oai.dtic.mil

Installation went very well, although the manual was generic and not specific to the model I bought. This made the assembly a little longer as there were no specific photos pertaining to the 7 stage unit. Unit comes 95% assembled and all fittings installed. All interconnecting tubing is precut and most is preassembled. The included universal adapter fittings for your plumbing made drain hookup a snap. Total install under the sink took about 3 hours (drilling, electric, etc.). Don't forget the electric outlet! Zero leaks after install. As the instructions say, the first few cups of water will come out quite warm because water surrounds the ultraviolet sterilizer bulb and it is always on. Great for tea or coffee, less microwave time. Let it run for 10 seconds and you're good. I am getting about 2.5 gallons out of the unit before pressure drops. It still puts out after that, ... full review
Formally, reverse osmosis is the process of forcing a solvent from a region of high solute concentration through a semipermeable membrane to a region of low-solute concentration by applying a pressure in excess of the osmotic pressure. The largest and most important application of reverse osmosis is the separation of pure water from seawater and brackish waters; seawater or brackish water is pressurized against one surface of the membrane, causing transport of salt-depleted water across the membrane and emergence of potable drinking water from the low-pressure side.

Each branch of the United States armed forces has their own series of reverse osmosis water purification unit models, but they are all similar. The water is pumped from its raw source into the reverse osmosis water purification unit module, where it is treated with a polymer to initiate coagulation. Next, it is run through a multi-media filter where it undergoes primary treatment by removing turbidity. It is then pumped through a cartridge filter which is usually spiral-wound cotton. This process clarifies the water of any particles larger than 5 µm and eliminates almost all turbidity.
Photo by marcos ojedaPrepackaged meals are the perfect camping food – lightweight, convenient, and easy to prepare. While many prepackaged meals are commercially available, you can save money, get the types of meals you want, and have fun by making your own. Fill a small freezer bag with ½ cup quick-cooking oats, a tablespoon of dry milk, a teaspoon of sugar, and a handful of dried fruit and nuts for a nutritious breakfast. For lunch, try a third of a cup of dry couscous, ½ cup freeze dried vegetables, a tablespoon of shelf stable shredded Parmesan cheese, a teaspoon of vegetable bullion and a few seasonings. How about rice with beef and mushrooms for dinner? And let’s not forget about desert; how does a mixed up fruit cobbler sound?
In this method, clean water should be brought to boil and left at rolling-boil for 1-3 minutes. For people living in high altitude areas, it is recommended to boil your water for longer than water boiled at lower altitudes. This is because water boils at lower temperatures in higher altitudes. Boiled water should be covered and left to cool before drinking. For water drawn from wells, leave it for compounds to settle before you filter out clean water for use.
After Hurricane Sandy, many homeowners used portable generators to replace lost power, leaving the machines running overnight and allowing odorless carbon monoxide to waft inside. The gas induces dizziness, headaches, and nausea in people who are awake, but "when people go to sleep with a generator running, there's no chance for them to realize that something's wrong," says Brett Brenner, president of the Electrical Safety Foundation International.
Prefiltration antiscalants: Scale inhibitors (also known as antiscalants) prevent formation of all scales compared to acid, which can only prevent formation of calcium carbonate and calcium phosphate scales. In addition to inhibiting carbonate and phosphate scales, antiscalants inhibit sulfate and fluoride scales and disperse colloids and metal oxides. Despite claims that antiscalants can inhibit silica formation, no concrete evidence proves that silica polymerization can be inhibited by antiscalants. Antiscalants can control acid-soluble scales at a fraction of the dosage required to control the same scale using sulfuric acid.[23]

Sea-water reverse-osmosis (SWRO) desalination, a membrane process, has been commercially used since the early 1970s. Its first practical use was demonstrated by Sidney Loeb from University of California at Los Angeles in Coalinga, California, and Srinivasa Sourirajan of National Research Council, Canada. Because no heating or phase changes are needed, energy requirements are low, around 3 kWh/m3, in comparison to other processes of desalination, but are still much higher than those required for other forms of water supply, including reverse osmosis treatment of wastewater, at 0.1 to 1 kWh/m3. Up to 50% of the seawater input can be recovered as fresh water, though lower recoveries may reduce membrane fouling and energy consumption.
Radium Removal: Some groundwater sources contain radium, a radioactive chemical element. Typical sources include many groundwater sources north of the Illinois River in Illinois, United States of America. Radium can be removed by ion exchange, or by water conditioning. The back flush or sludge that is produced is, however, a low-level radioactive waste.
×