Chlorine is a powerful chemical that has been in use for many years to treat water for home consumption. Chlorine is an effective water purification method that kills germs, parasites and other disease-causing organisms found in ground or tap water. Water can be purified using chlorine tablets or liquid chlorine. As an off-the-shelf water purification product, chlorine is cheap and effective. However, caution should be taken when using chlorine liquid or tablets to treat drinking water. For example, people suffering from thyroid problems should talk to a medical practitioner before using this product. When using chlorine tablets, it is important to apply them in heated water, as they dissolve well in water that is at 21 degree Celsius or higher. Chlorine tablets kill all bacteria leaving your water clean and safe.
Definitely, next time whenever you think about water filtration for home use Reverse Osmosis home system will pop up into your mind. This is the most durable, reliable and advanced way to produce clean and healthier water for your family. You don’t need to pay more for bottled water. It has the ability to knock down the taste and the quality of bottled water.

A process of osmosis through semipermeable membranes was first observed in 1748 by Jean-Antoine Nollet. For the following 200 years, osmosis was only a phenomenon observed in the laboratory. In 1950, the University of California at Los Angeles first investigated desalination of seawater using semipermeable membranes. Researchers from both University of California at Los Angeles and the University of Florida successfully produced fresh water from seawater in the mid-1950s, but the flux was too low to be commercially viable[4] until the discovery at University of California at Los Angeles by Sidney Loeb and Srinivasa Sourirajan[5] at the National Research Council of Canada, Ottawa, of techniques for making asymmetric membranes characterized by an effectively thin "skin" layer supported atop a highly porous and much thicker substrate region of the membrane. John Cadotte, of FilmTec Corporation, discovered that membranes with particularly high flux and low salt passage could be made by interfacial polymerization of m-phenylene diamine and trimesoyl chloride. Cadotte's patent on this process[6] was the subject of litigation and has since expired. Almost all commercial reverse-osmosis membrane is now made by this method. By the end of 2001, about 15,200 desalination plants were in operation or in the planning stages, worldwide.[2]
Information from Aquamira: "One unit will filter up to 20 gallons (75L) of water. Tests indicate that the Frontier Filter will remove 99.9% of Cryptosporidium and Giardia. The Frontier Emergency Water Filter System is also easy to operate, just attach and expand the straw, submerge the filter end into the water source, and drink through the straw."

In some systems, the carbon prefilter is omitted, and a cellulose triacetate membrane is used. CTA (cellulose triacetate) is a paper by-product membrane bonded to a synthetic layer and is made to allow contact with chlorine in the water. These require a small amount of chlorine in the water source to prevent bacteria from forming on it. The typical rejection rate for CTA membranes is 85–95%.


The first continuous use of chlorine in the United States for disinfection took place in 1908 at Boonton Reservoir (on the Rockaway River), which served as the supply for Jersey City, New Jersey.[46] Chlorination was achieved by controlled additions of dilute solutions of chloride of lime (calcium hypochlorite) at doses of 0.2 to 0.35 ppm. The treatment process was conceived by Dr. John L. Leal and the chlorination plant was designed by George Warren Fuller.[47] Over the next few years, chlorine disinfection using chloride of lime were rapidly installed in drinking water systems around the world.[48]
Remineralization stage adds back some beneficial minerals such as magnesium, calcium, and potassium to the purified water. This process is introduced to overcome the problem of acidic water. This addition of minerals gives the taste back to the water, which is removed in final filters. Remineralization enhanced the experience of purified water but it also makes the water more alkaline and less acidic.
The pore size of the filter, usually measured in microns, will determine what will be filtered through. While a standard micron size of 0.2 is small enough to block heavy metals such as lead and copper and large parasites such as Cryptosporidium, it will not block viruses. The National Sanitation Foundation sets a standard for effective water filtration products so look for an NSF stamp when selecting a filter to purchase.
In a reverse osmosis filter system, your regular water pressure pushes the water through a membrane and additional filters to remove impurities, which are then flushed down the drain. It’s a rigorous filtering process, a GE Reverse Osmosis System filters water three times, for example. Membranes and filters need to be replaced every six months to two years depending on the type of filter and how much water you use. 

Whether I've owned or rented. Country cottage, or city condo. The last one was a 2 stage G.E. undersink model which lasted about 9 years, until the filters started to get bad manufacture reviews. It's hard to find filter systems that are super quality, pro size, like the APEC WFS-1000 without going reverse osmosis. This system is the same size as a whole house filter, but made for undersink drinking water!
These tablets essentially use chlorination as their method of purification. Sodium chlorite generate chlorine dioxide giving it the ability to treat water. Chlorination, as most know, is a common method of disinfecting water, and is commonly used by municipalities world-wide for this purpose. Chlorine destroys bacteria by destroying the cell walls of the bacterium/virus, killing the organism. Fortunately, when we drink chlorinated water, our digestive system quickly neutralizes the chlorine. So chlorine concentrations along the gastrointestinal tract are, in all likelihood, too low to cause damage. The tablets are wrapped in a metallic foil which makes it easy to store and there are no concerns of a glass bottle breaking. This is one of our favorite items to carry as a backup to our water filtration system.
Purifying water can be done through a variety of methods, like using a filter, treating with chemicals, or boiling. Water should be purified whenever you have reason to believe that it could be contaminated. Typically, this is necessary if you are camping in the wilderness or your home water source has been compromised. Whatever the reason, purifying water will remove any sediments and contaminants, as well as kill any germs, so that you can enjoy clean water without worrying about getting sick.
Iodine solutions kill bacteria by upsetting the ion balance within the cell, replacing chemicals that the bacteria needs to survive with iodide ions. Iodine can also be poisonous to humans, and can be especially harmful to young children, and pregnant women. You should be careful not to use too much iodine when purifying your water, and if at all possible avoid using it as a primary purification method for extended periods of time. If you find yourself in a survival situation, for an extended period of time, you should consider setting up a still, or boiling the water if possible.
Remove heavy metals with cilantro. Just as pine trees are effective at removing pathogens, so too is cilantro excellent at removing heavy metals from water. Fill a pitcher with water and place a handful of cilantro leaves into the pitcher. Stir the water and let the leaves sit in the water for at least an hour. Remove and discard the cilantro before drinking the water.[11]
Countertop RO water systems are those systems that can be placed easily on the top of the Kitchen Table. These are designed for small families as they produce a small quantity of purified water. Countertop RO system is portable and inexpensive than most of other RO water filters. It is ideal for tenants who may not have permission to make changes in the house they live in.
• Snow: The energy it requires for your body to absorb the water from snow is high. Instead of eating the snow, melt it first. This can easily be done over a fire or with a camp stove. If those aren’t options, use the sun. Accelerate the process by chopping up ice and hanging it in a water bag in direct sunlight. If there’s no sun, use your body’s heat.
As with any other filter type water purification method, careful attention has to be taken to pathogen/virus and chemicals size. During hurricane Katrina a lot of the water was contaminated with petroleum based chemicals from flooded cars. What is removed from the water is dependent on the filter pore size. However, it is difficult to beat the lightweight option that water purification straws and bottles provide for most situations.
A reverse osmosis system is typically installed under the sink, but you can install it where your water enters the house, so all your water is filtered for contaminants. RO filter cartridges provide the most effective filtration of any water purifiers. The membrane and filters remove up to 99 percent of contaminants such as arsenic, lead, ammonia and chlorine, as well as toxic fluoride, sodium, nitrates and heavy metals. The 6 stage RO filters provide a deep filtering process, leaving you reverse osmosis water, free of sediments and toxins. RO water is perfect for drinking, cooking and making ice.
The process of distilling seawater into drinking water has been used by the Ancient Greeks since about 200 AD (Wikipedia). Many cultures throughout history have used distillation as an effective method of ensuring potable water. Although the materials used in the distillation process have changed over time, the science has remained the same, proving that distillation is a purification method that has stood the test of time.

Distillation is a water purification method that utilizes heat to collect pure water in the form of vapor. This method is effective by the scientific fact that water has a lower boiling point than other contaminants and disease-causing elements found in water. Water is subjected to a heat source until it attains its boiling point. It is then left at the boiling point until it vaporizes. This vapor is directed into a condenser to cool. Upon cooling, vapor is reversed into liquid water that is clean and safe for drinking. Other substances that have a higher boiling point are left as sediments in the container.

×