Filter out pathogens with pine trees. Certain plants are effective at removing pathogens from water, and pine trees are among the best. To remove viruses and bacteria from your water, remove a small branch from a pine tree. Strip the bark from the stick and place the bare stick into a bucket. Slowly pour the water, letting it trickle onto the stick and into the bucket.[10]


The addition of inorganic coagulants such as aluminum sulfate (or alum) or iron (III) salts such as iron(III) chloride cause several simultaneous chemical and physical interactions on and among the particles. Within seconds, negative charges on the particles are neutralized by inorganic coagulants. Also within seconds, metal hydroxide precipitates of the iron and aluminium ions begin to form. These precipitates combine into larger particles under natural processes such as Brownian motion and through induced mixing which is sometimes referred to as flocculation. Amorphous metal hydroxides are known as "floc". Large, amorphous aluminum and iron (III) hydroxides adsorb and enmesh particles in suspension and facilitate the removal of particles by subsequent processes of sedimentation and filtration.[6]:8.2–8.3
Waters exiting the flocculation basin may enter the sedimentation basin, also called a clarifier or settling basin. It is a large tank with low water velocities, allowing floc to settle to the bottom. The sedimentation basin is best located close to the flocculation basin so the transit between the two processes does not permit settlement or floc break up. Sedimentation basins may be rectangular, where water flows from end to end, or circular where flow is from the centre outward. Sedimentation basin outflow is typically over a weir so only a thin top layer of water—that furthest from the sludge—exits.
A reverse osmosis filter is the do-it-all of water purification. The process is the only one that addresses both harmful microorganisms and pollutants at the same time. It works by forcing water under pressure through a membrane made of thin film composite, with a inner matrix of dense polymers. The result leaves purified water on one side of the membrane, and contaminants on the other side. The technology is reliable, but expensive and relatively cumbersome, and requires electricity to work. It is therefore a sound choice for use in fixed positions or by those who can afford to tow a small trailer with a small electrical generator around, but anyone on the move or without access to electricity needs to use other methods.

• Snow: The energy it requires for your body to absorb the water from snow is high. Instead of eating the snow, melt it first. This can easily be done over a fire or with a camp stove. If those aren’t options, use the sun. Accelerate the process by chopping up ice and hanging it in a water bag in direct sunlight. If there’s no sun, use your body’s heat.

This is my second RO-PH90 system. Simply one of the best systems on the market, in my opinion. Uses genuine Dow filmtec reverse osmosis membrane. As anyone familiar with RO knows, filmtec membranes are the gold standard and rank among the elite in rejection rates. This is not your generic RO bought in a hardware store, although some large chains carry it. Input TDS = ~225 ppm, output TDS = ~15-20ppm. Does the job. Have not tested PH yet. Water tastes great as it does with my first system. Change your pre filters once per year or at the recommended %TDS interval and expect this RO membrane to last its full schedule of 3-5 years. This is very important. Incoming water pressure must be at least 50psi in my opinion, for this system to operate as intended. At 75psi, outgoing pressure is like a dream, even with 1/4'' stock tubing. ... full review
The goals of the treatment are to remove unwanted constituents in the water and to make it safe to drink or fit for a specific purpose in industry or medical applications. Widely varied techniques are available to remove contaminants like fine solids, micro-organisms and some dissolved inorganic and organic materials, or environmental persistent pharmaceutical pollutants. The choice of method will depend on the quality of the water being treated, the cost of the treatment process and the quality standards expected of the processed water.
Ion exchange:[11] Ion exchange systems use ion exchange resin- or zeolite-packed columns to replace unwanted ions. The most common case is water softening consisting of removal of Ca2+ and Mg2+ ions replacing them with benign (soap friendly) Na+ or K+ ions. Ion exchange resins are also used to remove toxic ions such as nitrite, lead, mercury, arsenic and many others.
• Snow: The energy it requires for your body to absorb the water from snow is high. Instead of eating the snow, melt it first. This can easily be done over a fire or with a camp stove. If those aren’t options, use the sun. Accelerate the process by chopping up ice and hanging it in a water bag in direct sunlight. If there’s no sun, use your body’s heat.

After Hurricane Sandy, many homeowners used portable generators to replace lost power, leaving the machines running overnight and allowing odorless carbon monoxide to waft inside. The gas induces dizziness, headaches, and nausea in people who are awake, but "when people go to sleep with a generator running, there's no chance for them to realize that something's wrong," says Brett Brenner, president of the Electrical Safety Foundation International.
You do not want to wait until you are thirsty to begin gathering water, as the urge to drink directly from the contaminated source can become unbearable. Due to the negative effects of drinking water contaminated with Giardia and other bacteria/viruses, this is a bad idea. Becoming sick from drinking bad water, will further dehydrate you, worsening your situation.
Reverse osmosis: Mechanical pressure is applied to an impure solution to force pure water through a semi-permeable membrane. Reverse osmosis is theoretically the most thorough method of large scale water purification available, although perfect semi-permeable membranes are difficult to create. Unless membranes are well-maintained, algae and other life forms can colonize the membranes.
Storage – Water from rivers may also be stored in bankside reservoirs for periods between a few days and many months to allow natural biological purification to take place. This is especially important if treatment is by slow sand filters. Storage reservoirs also provide a buffer against short periods of drought or to allow water supply to be maintained during transitory pollution incidents in the source river.
Organic polymers were developed in the 1960s as aids to coagulants and, in some cases, as replacements for the inorganic metal salt coagulants. Synthetic organic polymers are high molecular weight compounds that carry negative, positive or neutral charges. When organic polymers are added to water with particulates, the high molecular weight compounds adsorb onto particle surfaces and through interparticle bridging coalesce with other particles to form floc. PolyDADMAC is a popular cationic (positively charged) organic polymer used in water purification plants.[7]:667–8
STAT: The number of annual deaths from ESD in the U.S. are unknown, since they are counted among all drownings. But anecdotal evidence shows that ESD is widespread. ESD prevention groups have successfully urged some states to enact safety standards, including the installation of ground-fault circuit interrupters and a central shutoff for a dock's electrical system.
×