The first step calls for the installation of 2 push fit elbows. Note these were the only two elbows that leaked on me, despite use of thread tape and applying what I felt was the right torque. You really need to seat elbows well with the top of the male tread well below the plane of the housing. The push fits are of the type that once you push the poly tube in, that's it. So, being they are elbows, there is no coming back to easily address leak at the body joint. (I had NO push fit leaks in the system)... DONT Panic if it leaks at the body. Very careful removal of the inline filter and the RO membrane ... full review
Chlorine is effective against bacteria and most viruses. Norovirus, an intestinal disease that causes diarrhea, is particularly resistant to chlorine and will require the water to sit twice as long instead of the standard 30 minutes before consumption. Giardia, a parasite with a protective coating, will survive in chlorine treated water for 45 minutes before its safe to drink.
These tablets essentially use chlorination as their method of purification. Sodium chlorite generate chlorine dioxide giving it the ability to treat water. Chlorination, as most know, is a common method of disinfecting water, and is commonly used by municipalities world-wide for this purpose. Chlorine destroys bacteria by destroying the cell walls of the bacterium/virus, killing the organism. Fortunately, when we drink chlorinated water, our digestive system quickly neutralizes the chlorine. So chlorine concentrations along the gastrointestinal tract are, in all likelihood, too low to cause damage. The tablets are wrapped in a metallic foil which makes it easy to store and there are no concerns of a glass bottle breaking. This is one of our favorite items to carry as a backup to our water filtration system.
There are multiple built in filters water bottles choices. Vestergaard's Lifestraw Go and Sawyers Personal Water Bottle are two examples. The Lifestraw Go filters specs say it will filter up to 1,000 liters (264 gallons) of water down to particulate matter larger than 0.2 microns Source Sawyer's Personal Water bottle absolute hollow fiber membrane inline filter down to 0.1 micron. Source
Energy-recovery pump: a reciprocating piston pump having the pressurized concentrate flow applied to one side of each piston to help drive the membrane feed flow from the opposite side. These are the simplest energy recovery devices to apply, combining the high pressure pump and energy recovery in a single self-regulating unit. These are widely used on smaller low-energy systems. They are capable of 3 kWh/m3 or less energy consumption.
As particles settle to the bottom of a sedimentation basin, a layer of sludge is formed on the floor of the tank which must be removed and treated. The amount of sludge generated is significant, often 3 to 5 percent of the total volume of water to be treated. The cost of treating and disposing of the sludge can impact the operating cost of a water treatment plant. The sedimentation basin may be equipped with mechanical cleaning devices that continually clean its bottom, or the basin can be periodically taken out of service and cleaned manually.

As with any other filter type water purification method, careful attention has to be taken to pathogen/virus and chemicals size. During hurricane Katrina a lot of the water was contaminated with petroleum based chemicals from flooded cars. What is removed from the water is dependent on the filter pore size. However, it is difficult to beat the lightweight option that water purification straws and bottles provide for most situations.
In a paper published in 1894, Moritz Traube formally proposed the addition of chloride of lime (calcium hypochlorite) to water to render it "germ-free." Two other investigators confirmed Traube's findings and published their papers in 1895.[42] Early attempts at implementing water chlorination at a water treatment plant were made in 1893 in Hamburg, Germany and in 1897 the city of Maidstone, England was the first to have its entire water supply treated with chlorine.[43]
Visual inspection cannot determine if water is of appropriate quality. Simple procedures such as boiling or the use of a household activated carbon filter are not sufficient for treating all possible contaminants that may be present in water from an unknown source. Even natural spring water – considered safe for all practical purposes in the 19th century – must now be tested before determining what kind of treatment, if any, is needed. Chemical and microbiological analysis, while expensive, are the only way to obtain the information necessary for deciding on the appropriate method of purification.
It occurred to me that chlorine gas might be found satisfactory ... if suitable means could be found for using it.... The next important question was how to render the gas portable. This might be accomplished in two ways: By liquefying it, and storing it in lead-lined iron vessels, having a jet with a very fine capillary canal, and fitted with a tap or a screw cap. The tap is turned on, and the cylinder placed in the amount of water required. The chlorine bubbles out, and in ten to fifteen minutes the water is absolutely safe. This method would be of use on a large scale, as for service water carts.[49]
While the intermittent nature of sunlight and its variable intensity throughout the day makes PV efficiency prediction difficult and desalination during night time challenging, several solutions exist. For example, batteries, which provide the energy required for desalination in non-sunlight hours can be used to store solar energy in daytime. Apart from the use of conventional batteries, alternative methods for solar energy storage exist. For example, thermal energy storage systems solve this storage problem and ensure constant performance even during non-sunlight hours and cloudy days, improving overall efficiency.[13]
One of the first steps in most conventional water purification processes is the addition of chemicals to assist in the removal of particles suspended in water. Particles can be inorganic such as clay and silt or organic such as algae, bacteria, viruses, protozoa and natural organic matter. Inorganic and organic particles contribute to the turbidity and color of water.
Water conditioning: This is a method of reducing the effects of hard water. In water systems subject to heating hardness salts can be deposited as the decomposition of bicarbonate ions creates carbonate ions that precipitate out of solution. Water with high concentrations of hardness salts can be treated with soda ash (sodium carbonate) which precipitates out the excess salts, through the common-ion effect, producing calcium carbonate of very high purity. The precipitated calcium carbonate is traditionally sold to the manufacturers of toothpaste. Several other methods of industrial and residential water treatment are claimed (without general scientific acceptance) to include the use of magnetic and/or electrical fields reducing the effects of hard water.[20]
It isn’t the most affordable system, but it does reduce wastewater compared to many other systems. For every 1 gallon of purified water, there is just 1 gallon of wastewater, thanks in part to the permeate pump. Maintenance is easy for this reverse osmosis system—you’ll only need to change the filter once per year or every 2,000 gallons. So pour yourself a glass of clear, clean water and drink with peace of mind thanks to the Home Maker Full Contact Reverse Osmosis System!
Advantage is that you are not adding any chemicals to your water, which takes out the guess work as far as dosage. The disadvantage, if it can even be called that, is that you have to have a source of heat(fire, stove, etc.) in order to bring the water to the boiling point. Also we have to remember that this does not remove chemical such as petroleum or pesticides which can be harmful as well. 

While the intermittent nature of sunlight and its variable intensity throughout the day makes PV efficiency prediction difficult and desalination during night time challenging, several solutions exist. For example, batteries, which provide the energy required for desalination in non-sunlight hours can be used to store solar energy in daytime. Apart from the use of conventional batteries, alternative methods for solar energy storage exist. For example, thermal energy storage systems solve this storage problem and ensure constant performance even during non-sunlight hours and cloudy days, improving overall efficiency.[13]
×