Many books and articles suggest this method as a safe alternative when lacking water filtration or purification methods. Without testing equipment some methods are difficult to prove. Norseman of Survivology 101 posted two great blogs which include testing done while he trained with the Norwegian school of Winter Warfare. The testing shows that the Mash or Seep showed zero improvement in lowering the bacterial count. Norseman is a retired Marine who held a Scout Sniper Survival instructor position at the First Marine Division, and SERE instructor.
Household water treatment systems are composed of two categories: point-of-use and point-of-entryExternal (NSF). Point-of-entry systems are typically installed after the water meter and treat most of the water entering a residence. Point-of-use systems are systems that treat water in batches and deliver water to a tap, such as a kitchen or bathroom sink or an auxiliary faucet mounted next to a tap.
This water filtration system has 7 stages of treatment, including an 11-watt UV light to zap any microorganisms that may be lurking in well water. While this isn’t usually a major concern for homeowners on municipal water, the conditions of a well sometimes harbor bacteria and microorganisms that could pass through your plumbing and into your glass. A UV sterilizer is an efficient, effective way to eliminate this risk and have more peace of mind when drinking well water.
The system came in a well packaged box and I found everything easily including some spare parts for future use, which I appreciate. Fittings and pipes were included. All I need was the tools (wrench, scissors, etc) and a Teflon sealer that I got from Home Depot. I noticed a little trace of water and I found out that iSpring did a real test for quality control so that's a good ... full review
Large-scale industrial/municipal systems recover typically 75% to 80% of the feed water, or as high as 90%, because they can generate the high pressure needed for higher recovery reverse osmosis filtration. On the other hand, as recovery of wastewater increases in commercial operations, effective contaminant removal rates tend to become reduced, as evidenced by product water total dissolved solids levels.
Some small-scale desalination units use 'beach wells'; they are usually drilled on the seashore in close vicinity to the ocean. These intake facilities are relatively simple to build and the seawater they collect is pretreated via slow filtration through the subsurface sand/seabed formations in the area of source water extraction. Raw seawater collected using beach wells is often of better quality in terms of solids, silt, oil and grease, natural organic contamination and aquatic microorganisms, compared to open seawater intakes. Sometimes, beach intakes may also yield source water of lower salinity.