Different RO water filter systems handle a different number of purified gallons in a day. Normally this capacity goes from 50 to 150 Gallons per day and so on. You must identify the amount of water your family needs in a day. For Small families, reverse osmosis with 50 Gallons per day capacity is suggested while for larger families, Whole house Ro system with minimum 75-100 GPD is suggested.
Advantage is that you are not adding any chemicals to your water, which takes out the guess work as far as dosage. The disadvantage, if it can even be called that, is that you have to have a source of heat(fire, stove, etc.) in order to bring the water to the boiling point. Also we have to remember that this does not remove chemical such as petroleum or pesticides which can be harmful as well.
Reverse osmosis: Mechanical pressure is applied to an impure solution to force pure water through a semi-permeable membrane. Reverse osmosis is theoretically the most thorough method of large scale water purification available, although perfect semi-permeable membranes are difficult to create. Unless membranes are well-maintained, algae and other life forms can colonize the membranes.
One way to disinfect water through solar purification is through the use of plastic bottles and sunlight. Remove all labels and paper from the bottles and ensure they have no scratches. Fill them with water to about three quarters full, shake for a half-minute to activate the oxygen, fill with water to the brim, cover, and then lay it horizontally and expose to direct sunlight (Water Benefits Health).
Formally, reverse osmosis is the process of forcing a solvent from a region of high solute concentration through a semipermeable membrane to a region of low-solute concentration by applying a pressure in excess of the osmotic pressure. The largest and most important application of reverse osmosis is the separation of pure water from seawater and brackish waters; seawater or brackish water is pressurized against one surface of the membrane, causing transport of salt-depleted water across the membrane and emergence of potable drinking water from the low-pressure side.
As with any other filter type water purification method, careful attention has to be taken to pathogen/virus and chemicals size. During hurricane Katrina a lot of the water was contaminated with petroleum based chemicals from flooded cars. What is removed from the water is dependent on the filter pore size. However, it is difficult to beat the lightweight option that water purification straws and bottles provide for most situations.
In some systems, the carbon prefilter is omitted, and a cellulose triacetate membrane is used. CTA (cellulose triacetate) is a paper by-product membrane bonded to a synthetic layer and is made to allow contact with chlorine in the water. These require a small amount of chlorine in the water source to prevent bacteria from forming on it. The typical rejection rate for CTA membranes is 85–95%.
The booster pump included with this tankless reverse osmosis system requires electricity but helps to maximize the efficiency of the system. It can achieve up to a 1:1 ratio of purified to wastewater. However, in real-world use, some people found that wastewater was more like 2 gallons for every 1 gallon of purified water produced. iSprings points out that many factors affect this efficiency rating, so some variance in results is to be expected.
Installation went very well, although the manual was generic and not specific to the model I bought. This made the assembly a little longer as there were no specific photos pertaining to the 7 stage unit. Unit comes 95% assembled and all fittings installed. All interconnecting tubing is precut and most is preassembled. The included universal adapter fittings for your plumbing made drain hookup a snap. Total install under the sink took about 3 hours (drilling, electric, etc.). Don't forget the electric outlet! Zero leaks after install. As the instructions say, the first few cups of water will come out quite warm because water surrounds the ultraviolet sterilizer bulb and it is always on. Great for tea or coffee, less microwave time. Let it run for 10 seconds and you're good. I am getting about 2.5 gallons out of the unit before pressure drops. It still puts out after that, ... full review
The first part of the purification tag team must eliminate microorganisms, like harmful bacteria and parasites. There are a handful of tried and true methods for doing this. The most familiar is boiling. Simply bringing water up to its boiling point of 212 degrees Fahrenheit will kill almost all microorganisms, so just a few minutes of boiling will do the job.
Chlorine is a powerful chemical that has been in use for many years to treat water for home consumption. Chlorine is an effective water purification method that kills germs, parasites and other disease-causing organisms found in ground or tap water. Water can be purified using chlorine tablets or liquid chlorine. As an off-the-shelf water purification product, chlorine is cheap and effective. However, caution should be taken when using chlorine liquid or tablets to treat drinking water. For example, people suffering from thyroid problems should talk to a medical practitioner before using this product. When using chlorine tablets, it is important to apply them in heated water, as they dissolve well in water that is at 21 degree Celsius or higher. Chlorine tablets kill all bacteria leaving your water clean and safe.