The high pressure pump supplies the pressure needed to push water through the membrane, even as the membrane rejects the passage of salt through it. Typical pressures for brackish water range from 1.6 to 2.6 MPa (225 to 376 psi). In the case of seawater, they range from 5.5 to 8 MPa (800 to 1,180 psi). This requires a large amount of energy. Where energy recovery is used, part of the high pressure pump's work is done by the energy recovery device, reducing the system energy inputs.
Waters exiting the flocculation basin may enter the sedimentation basin, also called a clarifier or settling basin. It is a large tank with low water velocities, allowing floc to settle to the bottom. The sedimentation basin is best located close to the flocculation basin so the transit between the two processes does not permit settlement or floc break up. Sedimentation basins may be rectangular, where water flows from end to end, or circular where flow is from the centre outward. Sedimentation basin outflow is typically over a weir so only a thin top layer of water—that furthest from the sludge—exits.

The install took about 30 minutes to an hour working by myself. Most of the components are already connected together with most of the hookup being connecting the 3 large filters to the small filters and then the external hoses. The toughest part was installing the faucet but only because of my under sink area and working by myself. I did add a splitter to go to my refrigerator but it was easy to integrate.


A reverse osmosis system is typically installed under the sink, but you can install it where your water enters the house, so all your water is filtered for contaminants. RO filter cartridges provide the most effective filtration of any water purifiers. The membrane and filters remove up to 99 percent of contaminants such as arsenic, lead, ammonia and chlorine, as well as toxic fluoride, sodium, nitrates and heavy metals. The 6 stage RO filters provide a deep filtering process, leaving you reverse osmosis water, free of sediments and toxins. RO water is perfect for drinking, cooking and making ice.
The EPA states that there are four main types of contaminants to be found in water. The Safe Drinking Water Act (SDWA), a federal law that protects public drinking water supplies, defines "contaminant" as anything other than water molecules. We can reasonably expect most drinking water to contain some level of contaminant, especially since minerals such as calcium and magnesium fall into that category. The question is, which of these contaminants are harmful and how much of it is entering my system?
A reverse osmosis system is typically installed under the sink, but you can install it where your water enters the house, so all your water is filtered for contaminants. RO filter cartridges provide the most effective filtration of any water purifiers. The membrane and filters remove up to 99 percent of contaminants such as arsenic, lead, ammonia and chlorine, as well as toxic fluoride, sodium, nitrates and heavy metals. The 6 stage RO filters provide a deep filtering process, leaving you reverse osmosis water, free of sediments and toxins. RO water is perfect for drinking, cooking and making ice.
Remove heavy metals with cilantro. Just as pine trees are effective at removing pathogens, so too is cilantro excellent at removing heavy metals from water. Fill a pitcher with water and place a handful of cilantro leaves into the pitcher. Stir the water and let the leaves sit in the water for at least an hour. Remove and discard the cilantro before drinking the water.[11]
Depending upon the desired product, either the solvent or solute stream of reverse osmosis will be waste. For food concentration applications, the concentrated solute stream is the product and the solvent stream is waste. For water treatment applications, the solvent stream is purified water and the solute stream is concentrated waste.[28] The solvent waste stream from food processing may be used as reclaimed water, but there may be fewer options for disposal of a concentrated waste solute stream. Ships may use marine dumping and coastal desalination plants typically use marine outfalls. Landlocked reverse osmosis plants may require evaporation ponds or injection wells to avoid polluting groundwater or surface runoff.[29]
Energy-recovery pump: a reciprocating piston pump having the pressurized concentrate flow applied to one side of each piston to help drive the membrane feed flow from the opposite side. These are the simplest energy recovery devices to apply, combining the high pressure pump and energy recovery in a single self-regulating unit. These are widely used on smaller low-energy systems. They are capable of 3 kWh/m3 or less energy consumption.
The cellulose triacetate membrane is prone to rotting unless protected by chlorinated water, while the thin film composite membrane is prone to breaking down under the influence of chlorine. A thin film composite (TFC) membrane is made of synthetic material, and requires chlorine to be removed before the water enters the membrane. To protect the TFC membrane elements from chlorine damage, carbon filters are used as pre-treatment in all residential reverse osmosis systems. TFC membranes have a higher rejection rate of 95–98% and a longer life than CTA membranes.

A reverse osmosis filter is the do-it-all of water purification. The process is the only one that addresses both harmful microorganisms and pollutants at the same time. It works by forcing water under pressure through a membrane made of thin film composite, with a inner matrix of dense polymers. The result leaves purified water on one side of the membrane, and contaminants on the other side. The technology is reliable, but expensive and relatively cumbersome, and requires electricity to work. It is therefore a sound choice for use in fixed positions or by those who can afford to tow a small trailer with a small electrical generator around, but anyone on the move or without access to electricity needs to use other methods.
The water from this unit is pretty much tasteless to me, which is ideal since tap water tastes awful. I grew up with Culligan, which has a certain taste to me, versus this which is just pure. Haven't tested it but plan to. We also added a line to the fridge ice maker so our ice is purified. It was easy to install in our home, and we've used it three months with no issues. The cables are long. today when our sink clogged and we had to drain it, got a mess over all the filters, and they water tubes were all long enough to put the whole unit (still assembled and attached), into the sink to rinse it off. I'm glad it's made in the USA so I know all the parts have stringent manufacturing guidelines. The only thing I would change, is ordering directly from apec instead ... full review
×