Different RO water filter systems handle a different number of purified gallons in a day. Normally this capacity goes from 50 to 150 Gallons per day and so on. You must identify the amount of water your family needs in a day. For Small families, reverse osmosis with 50 Gallons per day capacity is suggested while for larger families, Whole house Ro system with minimum 75-100 GPD is suggested.
Filter out pathogens with pine trees. Certain plants are effective at removing pathogens from water, and pine trees are among the best. To remove viruses and bacteria from your water, remove a small branch from a pine tree. Strip the bark from the stick and place the bare stick into a bucket. Slowly pour the water, letting it trickle onto the stick and into the bucket.[10]
Radium Removal: Some groundwater sources contain radium, a radioactive chemical element. Typical sources include many groundwater sources north of the Illinois River in Illinois, United States of America. Radium can be removed by ion exchange, or by water conditioning. The back flush or sludge that is produced is, however, a low-level radioactive waste.
Coagulation and flocculation are often the first steps in water treatment. Chemicals with a positive charge are added to the water. The positive charge of these chemicals neutralizes the negative charge of dirt and other dissolved particles in the water. When this occurs, the particles bind with the chemicals and form larger particles, called floc.
This system can purify up to 50 gallons of water per day and has 5 stages of filtration to remove up to 99 percent of TDS. For every gallon of purified water produced, there are 3 gallons of wastewater. This is an average conversion rate and is much better than some water filtration systems that have 4 or 5 gallons of wastewater for every purified gallon produced.

As with any other filter type water purification method, careful attention has to be taken to pathogen/virus and chemicals size. During hurricane Katrina a lot of the water was contaminated with petroleum based chemicals from flooded cars. What is removed from the water is dependent on the filter pore size. However, it is difficult to beat the lightweight option that water purification straws and bottles provide for most situations.
The first part of the purification tag team must eliminate microorganisms, like harmful bacteria and parasites. There are a handful of tried and true methods for doing this. The most familiar is boiling. Simply bringing water up to its boiling point of 212 degrees Fahrenheit will kill almost all microorganisms, so just a few minutes of boiling will do the job.
×