The system came in a well packaged box and I found everything easily including some spare parts for future use, which I appreciate. Fittings and pipes were included. All I need was the tools (wrench, scissors, etc) and a Teflon sealer that I got from Home Depot. I noticed a little trace of water and I found out that iSpring did a real test for quality control so that's a good ... full review
There are multiple levels of filtration. As long as the water has been purified properly, filtration at this point would mostly be to make the water more attractive. Since most of us are not used to, drinking water with, leaves, algae, dirt, etcetera. So, at least a minimal amount of filtration is recommended. Since, while you can ingest/digest the aforementioned, most of us would prefer not to.
Furthermore, animals have to drink and are known to visit water holes. This raises several concerns, 1) Animals are not very mindful of their toilet etiquette and 2) Predators will sometimes use water holes as a place of attack. If we were desperate, (dying of thirst) and had no way to purify the water, first we really should ask ourselves how we got ourselves into such a situation, then we would have no choice but to drink the water in hopes that we are rescued before the water borne disease kills us. Think outside the box, is there a way to get a makeshift bowl (wood, vegetation) and use hot rocks to boil the water. Is there any material around, bamboo etc that can be used to slowly bring the water to a boil. Build a multiple stage filter using sand, charcoal and sphagnum moss which has been known to contain some levels of iodine. If all that fails then we would be faced with the choice of drinking the untreated water. We know that moving water is preferable to standing water, but what can we do. We can walk around the water source, find the area with the least animal traffic and preferably a sandy shoreline. We can then dig a hole near the water deep enough to allow water to collect. The distance from the water source will have to be judged by the soil we are digging. The hope here is that the water will slowly seep into the hole and begin to collect while being "filtered" by the sand and rocks. At this point we have to get creative to get the water out. Perhaps make a straw out of natural materials or simply soak a bandana and squeeze it into our mouth. This would be a last resort and very risky.
The pore size of the filter, usually measured in microns, will determine what will be filtered through. While a standard micron size of 0.2 is small enough to block heavy metals such as lead and copper and large parasites such as Cryptosporidium, it will not block viruses. The National Sanitation Foundation sets a standard for effective water filtration products so look for an NSF stamp when selecting a filter to purchase.
Thanks a lot to KPS for sharing such an informative article about outdoor travel survival tips. I have read your valuable page and gotten much information and now my confused has cleared. I love travel. But I have a little question that, I have a little baby but how to take care in travel time? And which foods are good for baby survival times? And which dress will be comfortable for baby in survival time? Could you please suggest me? Then I will be benefited. Anyway, I will share this article with my friends. I hope they will be benefited by this article.
After installation, you have to fill and empty the tank to make it active. Normally you have filled and empty for 3-4 times but it depends on the system. You can check out how much water wastage is required from your instructional manual. This step in crucial. You will not have the safer, cleaner healthier purified water until you complete the last step.
Pure water has a pH close to 7 (neither alkaline nor acidic). Sea water can have pH values that range from 7.5 to 8.4 (moderately alkaline). Fresh water can have widely ranging pH values depending on the geology of the drainage basin or aquifer and the influence of contaminant inputs (acid rain). If the water is acidic (lower than 7), lime, soda ash, or sodium hydroxide can be added to raise the pH during water purification processes. Lime addition increases the calcium ion concentration, thus raising the water hardness. For highly acidic waters, forced draft degasifiers can be an effective way to raise the pH, by stripping dissolved carbon dioxide from the water.[4] Making the water alkaline helps coagulation and flocculation processes work effectively and also helps to minimize the risk of lead being dissolved from lead pipes and from lead solder in pipe fittings. Sufficient alkalinity also reduces the corrosiveness of water to iron pipes. Acid (carbonic acid, hydrochloric acid or sulfuric acid) may be added to alkaline waters in some circumstances to lower the pH. Alkaline water (above pH 7.0) does not necessarily mean that lead or copper from the plumbing system will not be dissolved into the water. The ability of water to precipitate calcium carbonate to protect metal surfaces and reduce the likelihood of toxic metals being dissolved in water is a function of pH, mineral content, temperature, alkalinity and calcium concentration.[5]
Many books and articles suggest this method as a safe alternative when lacking water filtration or purification methods. Without testing equipment some methods are difficult to prove. Norseman of Survivology 101 posted two great blogs which include testing done while he trained with the Norwegian school of Winter Warfare. The testing shows that the Mash or Seep showed zero improvement in lowering the bacterial count. Norseman is a retired Marine who held a Scout Sniper Survival instructor position at the First Marine Division, and SERE instructor.

There are five types of contaminants that are found in water: particulates, bacteria, minerals, chemicals, and pharmaceuticals. Methods to remove these elements range from simple and inexpensive to elaborate and costly. Often to achieve purely potable water, several technologies must be combined in a particular sequence. Listed here are general brief descriptions of the twenty-five methods to purify water.

Thanks a lot to KPS for sharing such an informative article about outdoor travel survival tips. I have read your valuable page and gotten much information and now my confused has cleared. I love travel. But I have a little question that, I have a little baby but how to take care in travel time? And which foods are good for baby survival times? And which dress will be comfortable for baby in survival time? Could you please suggest me? Then I will be benefited. Anyway, I will share this article with my friends. I hope they will be benefited by this article.


In some systems, the carbon prefilter is omitted, and a cellulose triacetate membrane is used. CTA (cellulose triacetate) is a paper by-product membrane bonded to a synthetic layer and is made to allow contact with chlorine in the water. These require a small amount of chlorine in the water source to prevent bacteria from forming on it. The typical rejection rate for CTA membranes is 85–95%.
Waters exiting the flocculation basin may enter the sedimentation basin, also called a clarifier or settling basin. It is a large tank with low water velocities, allowing floc to settle to the bottom. The sedimentation basin is best located close to the flocculation basin so the transit between the two processes does not permit settlement or floc break up. Sedimentation basins may be rectangular, where water flows from end to end, or circular where flow is from the centre outward. Sedimentation basin outflow is typically over a weir so only a thin top layer of water—that furthest from the sludge—exits.

Photo by marcos ojedaPrepackaged meals are the perfect camping food – lightweight, convenient, and easy to prepare. While many prepackaged meals are commercially available, you can save money, get the types of meals you want, and have fun by making your own. Fill a small freezer bag with ½ cup quick-cooking oats, a tablespoon of dry milk, a teaspoon of sugar, and a handful of dried fruit and nuts for a nutritious breakfast. For lunch, try a third of a cup of dry couscous, ½ cup freeze dried vegetables, a tablespoon of shelf stable shredded Parmesan cheese, a teaspoon of vegetable bullion and a few seasonings. How about rice with beef and mushrooms for dinner? And let’s not forget about desert; how does a mixed up fruit cobbler sound?

Hikers on a glacier or in areas where patches of snow remain above the tree line may be tempted to speed downhill by sliding, or glissading. Bad idea: A gentle glide can easily lead to an unstoppable plummet. In 2005 climber Patrick Wang, 27, died on California's Mount Whitney while glissading off the summit; he slid 300 feet before falling off a 1000-foot cliff.


Ultraviolet light (UV) is very effective at inactivating cysts, in low turbidity water. UV light's disinfection effectiveness decreases as turbidity increases, a result of the absorption, scattering, and shadowing caused by the suspended solids. The main disadvantage to the use of UV radiation is that, like ozone treatment, it leaves no residual disinfectant in the water; therefore, it is sometimes necessary to add a residual disinfectant after the primary disinfection process. This is often done through the addition of chloramines, discussed above as a primary disinfectant. When used in this manner, chloramines provide an effective residual disinfectant with very few of the negative effects of chlorination.
Membrane filters are widely used for filtering both drinking water and sewage. For drinking water, membrane filters can remove virtually all particles larger than 0.2 μm—including giardia and cryptosporidium. Membrane filters are an effective form of tertiary treatment when it is desired to reuse the water for industry, for limited domestic purposes, or before discharging the water into a river that is used by towns further downstream. They are widely used in industry, particularly for beverage preparation (including bottled water). However no filtration can remove substances that are actually dissolved in the water such as phosphates, nitrates and heavy metal ions.
The first part of the purification tag team must eliminate microorganisms, like harmful bacteria and parasites. There are a handful of tried and true methods for doing this. The most familiar is boiling. Simply bringing water up to its boiling point of 212 degrees Fahrenheit will kill almost all microorganisms, so just a few minutes of boiling will do the job.
The first experiments into water filtration were made in the 17th century. Sir Francis Bacon attempted to desalinate sea water by passing the flow through a sand filter. Although his experiment did not succeed, it marked the beginning of a new interest in the field. The fathers of microscopy, Antonie van Leeuwenhoek and Robert Hooke, used the newly invented microscope to observe for the first time small material particles that lay suspended in the water, laying the groundwork for the future understanding of waterborne pathogens.[36]
In a reverse osmosis filter system, your regular water pressure pushes the water through a membrane and additional filters to remove impurities, which are then flushed down the drain. It’s a rigorous filtering process, a GE Reverse Osmosis System filters water three times, for example. Membranes and filters need to be replaced every six months to two years depending on the type of filter and how much water you use.

Fluoride Removal: Although fluoride is added to water in many areas, some areas of the world have excessive levels of natural fluoride in the source water. Excessive levels can be toxic or cause undesirable cosmetic effects such as staining of teeth. Methods of reducing fluoride levels is through treatment with activated alumina and bone char filter media.
Whether I've owned or rented. Country cottage, or city condo. The last one was a 2 stage G.E. undersink model which lasted about 9 years, until the filters started to get bad manufacture reviews. It's hard to find filter systems that are super quality, pro size, like the APEC WFS-1000 without going reverse osmosis. This system is the same size as a whole house filter, but made for undersink drinking water!

The most common disinfection method involves some form of chlorine or its compounds such as chloramine or chlorine dioxide. Chlorine is a strong oxidant that rapidly kills many harmful micro-organisms. Because chlorine is a toxic gas, there is a danger of a release associated with its use. This problem is avoided by the use of sodium hypochlorite, which is a relatively inexpensive solution used in household bleach that releases free chlorine when dissolved in water. Chlorine solutions can be generated on site by electrolyzing common salt solutions. A solid form, calcium hypochlorite, releases chlorine on contact with water. Handling the solid, however, requires more routine human contact through opening bags and pouring than the use of gas cylinders or bleach, which are more easily automated. The generation of liquid sodium hypochlorite is inexpensive and also safer than the use of gas or solid chlorine. Chlorine levels up to 4 milligrams per liter (4 parts per million) are considered safe in drinking water.[12]


Definitely, next time whenever you think about water filtration for home use Reverse Osmosis home system will pop up into your mind. This is the most durable, reliable and advanced way to produce clean and healthier water for your family. You don’t need to pay more for bottled water. It has the ability to knock down the taste and the quality of bottled water.
If you want to take a long swim underwater, the trick is to breathe in and out a few times and take a big gulp of air before you submerge. Right? Dead wrong. Hyperventilating not only doesn't increase the oxygen in your blood, it also decreases the amount of CO2, the compound that informs the brain of the need to breathe. Without that natural signal, you may hold your breath until you pass out and drown. This is known as shallow-water blackout.
×