There is another method that produces fully purified water in one step, and that is distillation. A solar still can be built by digging a hole, putting an empty pan in the bottom, setting a bucket full of impure water into the middle of the pan, and then setting a peaked clear plastic sheet over top. This will evaporate the water out of the impurities, collect and condense it inside the plastic, and let it drip down into the empty pan. The problem with this method is that it is very slow and produces relatively little water.

In this method, clean water should be brought to boil and left at rolling-boil for 1-3 minutes. For people living in high altitude areas, it is recommended to boil your water for longer than water boiled at lower altitudes. This is because water boils at lower temperatures in higher altitudes. Boiled water should be covered and left to cool before drinking. For water drawn from wells, leave it for compounds to settle before you filter out clean water for use.
The APEC Ultimate 6-Stage Reverse Osmosis system removes up to 99 percent of bacteria, contaminants, and solids. But it also adds back in calcium and magnesium, which are beneficial minerals for your health and improve the taste of drinking water. The system is rated for purifying up to 75 gallons per day, which is plenty for the average family’s daily needs. The system includes a flow restrictor and an automatic shutoff valve that help to reduce wastewater to 3 gallons for every 1 gallon of purified water produced. Some other systems produce in excess of 5 gallons of wastewater to every 1 gallon of purified water.

Despite its efficiency in killing microorganisms, UV radiation will not remove heavy metals and particles. Something else to consider is the high maintenance requirement for a UV purification system. Frequent cleaning and proper part replacement are necessary requirements in maintaining a properly functioning system. Read our article on UV water purification systems for home to find out more.


The install took about 30 minutes to an hour working by myself. Most of the components are already connected together with most of the hookup being connecting the 3 large filters to the small filters and then the external hoses. The toughest part was installing the faucet but only because of my under sink area and working by myself. I did add a splitter to go to my refrigerator but it was easy to integrate.

Ultraviolet light (UV) is very effective at inactivating cysts, in low turbidity water. UV light's disinfection effectiveness decreases as turbidity increases, a result of the absorption, scattering, and shadowing caused by the suspended solids. The main disadvantage to the use of UV radiation is that, like ozone treatment, it leaves no residual disinfectant in the water; therefore, it is sometimes necessary to add a residual disinfectant after the primary disinfection process. This is often done through the addition of chloramines, discussed above as a primary disinfectant. When used in this manner, chloramines provide an effective residual disinfectant with very few of the negative effects of chlorination.
×