It’s extremely important to confirm your water has been purified or treated before drinking. If your water is contaminated and you don’t have bottled water, there are various water purification methods that are used today, and each method has its merits and demerits. Filtering is good for basic water tasks such as sediment and chlorine removal, but in the long run reverse osmosis is the best option. At Schultz Soft Water we focus on reverse osmosis units because they require a lot less energy and time required to make water versus distillation.
Strain the water. For water that’s contaminated with large particles like pebbles, insects, plant matter, or dirt, you can strain out the contaminants.[1] Line a fine-mesh strainer with muslin, cheesecloth, a clean dish towel, or even a clean cotton shirt. Place the strainer over a bowl, and pour the water through the strainer to remove the particles.

Distillation involves boiling the water to produce water vapour. The vapour contacts a cool surface where it condenses as a liquid. Because the solutes are not normally vaporised, they remain in the boiling solution. Even distillation does not completely purify water, because of contaminants with similar boiling points and droplets of unvapourised liquid carried with the steam. However, 99.9% pure water can be obtained by distillation.
You can get an unlimited supply of pure water right from your kitchen. It can remove 99% of harmful contaminants from the feed water. The quality of filtered water depends upon the feed water. If you have doubt on your water source or have a large number of microorganisms then you should not rely on this RO Unit as it does not have the advanced stages like UV Filter which can deal with the microorganisms.
The Lifestraw go simplifies water purification by allowing users to scoop water from a river or other unsafe water source into the bottle, screw the lid on, and sip clean water through the mouthpiece. We have not had the opportunity to test the Lifestraw go. We would be interested in comparing it to the Sawyer Personal Water Bottle. Our next post will be a test of the Sawyer bottle.

Strain the water. For water that’s contaminated with large particles like pebbles, insects, plant matter, or dirt, you can strain out the contaminants.[1] Line a fine-mesh strainer with muslin, cheesecloth, a clean dish towel, or even a clean cotton shirt. Place the strainer over a bowl, and pour the water through the strainer to remove the particles.

• Advanced: A battery can be used to create a spark to light tinder. Use your vehicle battery (removed from vehicle or boat) by attaching wires or steel wool to connect the positive and negative posts. This will induce a spark or ignite the wool. With smaller batteries, align two batteries together, positive to negative. Use strands of steel wool to connect the posts to create a spark and ignite wool. A 9-volt battery works great.
As with any other filter type water purification method, careful attention has to be taken to pathogen/virus and chemicals size. During hurricane Katrina a lot of the water was contaminated with petroleum based chemicals from flooded cars. What is removed from the water is dependent on the filter pore size. However, it is difficult to beat the lightweight option that water purification straws and bottles provide for most situations.
×