The Lifestraw go simplifies water purification by allowing users to scoop water from a river or other unsafe water source into the bottle, screw the lid on, and sip clean water through the mouthpiece. We have not had the opportunity to test the Lifestraw go. We would be interested in comparing it to the Sawyer Personal Water Bottle. Our next post will be a test of the Sawyer bottle.


Pretreatment is important when working with reverse osmosis and nanofiltration membranes due to the nature of their spiral-wound design. The material is engineered in such a fashion as to allow only one-way flow through the system. As such, the spiral-wound design does not allow for backpulsing with water or air agitation to scour its surface and remove solids. Since accumulated material cannot be removed from the membrane surface systems, they are highly susceptible to fouling (loss of production capacity). Therefore, pretreatment is a necessity for any reverse osmosis or nanofiltration system. Pretreatment in sea water reverse osmosis systems has four major components:
If you want to take a long swim underwater, the trick is to breathe in and out a few times and take a big gulp of air before you submerge. Right? Dead wrong. Hyperventilating not only doesn't increase the oxygen in your blood, it also decreases the amount of CO2, the compound that informs the brain of the need to breathe. Without that natural signal, you may hold your breath until you pass out and drown. This is known as shallow-water blackout.
Reverse osmosis differs from filtration in that the mechanism of fluid flow is by osmosis across a membrane. The predominant removal mechanism in membrane filtration is straining, or size exclusion, where the pores are 0.01 micrometers or larger, so the process can theoretically achieve perfect efficiency regardless of parameters such as the solution's pressure and concentration. Reverse osmosis instead involves solvent diffusion across a membrane that is either nonporous or uses nanofiltration with pores 0.001 micrometers in size. The predominant removal mechanism is from differences in solubility or diffusivity, and the process is dependent on pressure, solute concentration, and other conditions.[2] Reverse osmosis is most commonly known for its use in drinking water purification from seawater, removing the salt and other effluent materials from the water molecules.[3]
It occurred to me that chlorine gas might be found satisfactory ... if suitable means could be found for using it.... The next important question was how to render the gas portable. This might be accomplished in two ways: By liquefying it, and storing it in lead-lined iron vessels, having a jet with a very fine capillary canal, and fitted with a tap or a screw cap. The tap is turned on, and the cylinder placed in the amount of water required. The chlorine bubbles out, and in ten to fifteen minutes the water is absolutely safe. This method would be of use on a large scale, as for service water carts.[49]
Many books and articles suggest this method as a safe alternative when lacking water filtration or purification methods. Without testing equipment some methods are difficult to prove. Norseman of Survivology 101 posted two great blogs which include testing done while he trained with the Norwegian school of Winter Warfare. The testing shows that the Mash or Seep showed zero improvement in lowering the bacterial count. Norseman is a retired Marine who held a Scout Sniper Survival instructor position at the First Marine Division, and SERE instructor.
"The overall study results revealed that the CHLOR-FLOC system was not adequate to physically remove, or to provide adequate chemical disinfection of, Cryptosporidium oocysts to the required level of 99.9 percent reduction. Water, Purification, CHLOR-FLOC tablets, Micro-organisms, Cryptosporidium, Klebseilla, Echovirus, Latex beads, Protozoan cysts, Bacteria, Disinfection, Coagulation." Source: oai.dtic.mil
Bioremediation is a technique that uses microorganisms in order to remove or extract certain waste products from a contaminated area. Since 1991 bioremediation has been a suggested tactic to remove impurities from water such as alkanes, perchlorates, and metals.[26] The treatment of ground and surface water, through bioremediation, with respect to perchlorate and chloride compounds, has seen success as perchlorate compounds are highly soluble making it difficult to remove.[27] Such success by use of Dechloromonas agitata strain CKB include field studies conducted in Maryland and the Southwest region of the United States.[27][28][29] Although a bioremediation technique may be successful, implementation is not feasible as there is still much to be studied regarding rates and after effects of microbial activity as well as producing a large scale implementation method.
Compared to reverse osmosis, filtration is considered effective when it comes to selective elimination of much smaller molecular compounds such as chlorine and pesticides. The other factor that makes filtration less costly is that it does not require a lot of energy needed in distillation and reverse osmosis. It is an economic method of water purification because little water is lost during purification.
While nearly everyone loves the taste from this water filtration system, a few people tested the pH and complained that it wasn’t as alkaline as they hoped for in a system that adds back beneficial minerals. However, the company points out that the pH filter will raise acidity by 1-1.5 levels, so the final pH will depend on the chemistry of the water that you’re starting with. 
The most common disinfection method involves some form of chlorine or its compounds such as chloramine or chlorine dioxide. Chlorine is a strong oxidant that rapidly kills many harmful micro-organisms. Because chlorine is a toxic gas, there is a danger of a release associated with its use. This problem is avoided by the use of sodium hypochlorite, which is a relatively inexpensive solution used in household bleach that releases free chlorine when dissolved in water. Chlorine solutions can be generated on site by electrolyzing common salt solutions. A solid form, calcium hypochlorite, releases chlorine on contact with water. Handling the solid, however, requires more routine human contact through opening bags and pouring than the use of gas cylinders or bleach, which are more easily automated. The generation of liquid sodium hypochlorite is inexpensive and also safer than the use of gas or solid chlorine. Chlorine levels up to 4 milligrams per liter (4 parts per million) are considered safe in drinking water.[12]
I have wanted an RO system for awhile and this seemed the best for a reasonable price. Great water filtration, very fast faucet flow, great water conservation for RO, and easy to install. After four hours today I have it installed and I tested my tap water, my brita pitcher, and then the RO water with a TDS meter (which measures the total dissolved solids in a liquid) and aquarium PH liquid tests (best thing I had on hand). Also I am 21 and havent done anything like this before but I think for what it is it was pretty easy to install. I will post my results from the tests below, they speak for themselves. My Brita Pitcher was BS and RO cant be beat. I will post another review if anything happens in the next year or so to make sure these results last.
DO: Ride only off-road. Paul Vitrano, executive vice president of the ATV Safety Institute, says, "Soft, knobby tires are designed for traction on uneven ground and will behave unpredictably on pavement." In some cases, tires will grip enough to cause an ATV to flip, as in the recent Nevada incident. "If you must cross a paved road to continue on an approved trail, go straight across in first gear."

What many poor people, backcountry hikers, and those living in remote areas have in common are a reliance on untreated, local sources of water that may be contaminated, and must be purified before it can be safely consumed. There are two basic approaches to water purification: using a reverse osmosis filter, or a tag team of two methods working together to eliminate two separate contaminants.


As with any other filter type water purification method, careful attention has to be taken to pathogen/virus and chemicals size. During hurricane Katrina a lot of the water was contaminated with petroleum based chemicals from flooded cars. What is removed from the water is dependent on the filter pore size. However, it is difficult to beat the lightweight option that water purification straws and bottles provide for most situations.
The reverse osmosis membrane used in the RCC7AK is rated for up to 75 gallons per day, which is plenty to meet the needs of most households shopping for an under sink reverse osmosis system. It takes anywhere from 1 to 3 hours to fill the storage tank, but once the tank is full, you’ll have purified water ready and waiting under the sink. A lead-free brushed nickel metal faucet for countertop installation is included so you can bypass the tap and have fresh, clean water on demand.
• Snow: The energy it requires for your body to absorb the water from snow is high. Instead of eating the snow, melt it first. This can easily be done over a fire or with a camp stove. If those aren’t options, use the sun. Accelerate the process by chopping up ice and hanging it in a water bag in direct sunlight. If there’s no sun, use your body’s heat.

Gas hydrate crystals centrifuge method. If carbon dioxide or other low molecular weight gas is mixed with contaminated water at high pressure and low temperature, gas hydrate crystals will form exothermically. Separation of the crystalline hydrate may be performed by centrifuge or sedimentation and decanting. Water can be released from the hydrate crystals by heating[25]
Water conditioning: This is a method of reducing the effects of hard water. In water systems subject to heating hardness salts can be deposited as the decomposition of bicarbonate ions creates carbonate ions that precipitate out of solution. Water with high concentrations of hardness salts can be treated with soda ash (sodium carbonate) which precipitates out the excess salts, through the common-ion effect, producing calcium carbonate of very high purity. The precipitated calcium carbonate is traditionally sold to the manufacturers of toothpaste. Several other methods of industrial and residential water treatment are claimed (without general scientific acceptance) to include the use of magnetic and/or electrical fields reducing the effects of hard water.[20]
Obviously, reverse osmosis water system for the home will occupy some space in the kitchen. You must have a rough estimate of how much space your reverse osmosis system is going to take. The best approach to have an idea is to first decide whether you are going to set up it on the kitchen table or under the sink. After deciding, measure the space and then check the dimensions of the system that you have chosen.
A solar-powered desalination unit produces potable water from saline water by using a photovoltaic system that converts solar power into the required energy for reverse osmosis. Due to the extensive availability of sunlight across different geographies, solar-powered reverse osmosis lends itself well to drinking water purification in remote settings lacking an electricity grid. Moreover, Solar energy overcomes the usually high-energy operating costs as well as greenhouse emissions of conventional reverse osmosis systems, making it a sustainable freshwater solution compatible to developing contexts. For example, a solar-powered desalination unit designed for remote communities has been successfully tested in the Northern Territory of Australia.[12]
A reverse osmosis filter is the do-it-all of water purification. The process is the only one that addresses both harmful microorganisms and pollutants at the same time. It works by forcing water under pressure through a membrane made of thin film composite, with a inner matrix of dense polymers. The result leaves purified water on one side of the membrane, and contaminants on the other side. The technology is reliable, but expensive and relatively cumbersome, and requires electricity to work. It is therefore a sound choice for use in fixed positions or by those who can afford to tow a small trailer with a small electrical generator around, but anyone on the move or without access to electricity needs to use other methods.
On May 20, 2013, Kyle McGonigle was on a dock on Kentucky's Rough River Lake. A dog swimming nearby yelped, and McGonigle, 36, saw that it was struggling to stay above water. He dove in to save the dog, but both he and the animal drowned, victims of electric-shock drowning (ESD). Cords plugged into an outlet on the dock had slipped into the water and electrified it.
Like most under sink reverse osmosis systems, you’ll need to clear enough space for the 3.2-gallon pressurized storage tank and the filter cartridges. But once you do, you’ll find that the rest of the installation is easy according to most reviewers. One user mentions that they move every 3 years but are happy to uninstall and re-install the system in each new residence due to the high performance and easy set-up of the iSprings RCC7AK.

Advantage is that you are not adding any chemicals to your water, which takes out the guess work as far as dosage. The disadvantage, if it can even be called that, is that you have to have a source of heat(fire, stove, etc.) in order to bring the water to the boiling point. Also we have to remember that this does not remove chemical such as petroleum or pesticides which can be harmful as well.
×